dell studio 1537 power button wiring

Remove these seals with a sharp object and remove screws found under the seals.
You can remove and replace the inverter board without removing the screen.
Turn the laptop upside down and disconnect two antenna cables from the wireless card.
By the way, HP G50/G60/G70 models also known as Compaq Presario CQ50, Presario CQ60 and Presario CQ70.It is not necessary to remove the memory and hard drive covers.If you work slowly, everything should be fine.Remove two screws securing the left display hinge.Thats a legitimate claim nfs most wanted cars mods as long as you are using the item for the purpose for which it was intended.Remove one screw securing the Wi-Fi cover and remove the cover.By the way, this is the backlight connector.Turn off the laptop and remove the battery.In G70 notebooks there are only two screws securing the keyboard and they are located on priston tale 2 gamerkraft the bottom (there is a small keyboard stamped close to each screw).Disconnect the switch board cable from the motherboard.There are two screw seals located in the lower left and right corners.Do the same with the other side.




This is the principle of fitness for purpose.The white clip must stay attached to the connector base.I marked them just for your convenience.Service manual for HP G50 or Compaq Presario CQ50 (page 57).Similarly, if you are commissioning the manufacture of a product and do not specify the purposes for which it will be used you will have no recourse if it fails to live up to your expectations.Remove the inverter board from the cover and disconnect one connector from the right side.Remove the keyboard cover.If you are using this guide for replacing the keyboard, you have to remove only three (yellow) screws.Start separating the bezel from the display cover.Youll have to disconnect the cable from the webcam before disconnecting the video cable.