hp procurve fabric module

The connecting switch must also be configured for trunking.
One of the early customers is London's.To comment on this the songs of distant earth ebook article and other PCWorld content, visit our.This allows a management module to fail without dropping packets.We spent years designing this silicon, this generation alone took an investment of around 50 million.".It is now the number two in Europe with around 16 percent, according to market researcher Dell'Oro, although of course it is still a long way behind.HP-Switch(Config ip route /24 (Routes the subnet /24 to ).Useful for bridging devices).HP ProCurve has introduced a high-end core switch pitched against Cisco's.HP-Switch(Config show lacp (Displays information about lacp status on port members).This is Active/Passive) HP-Switch(Config redundancy active-management management-module2 (Will make management module 2 active on next boot) HP-Switch(Config redundancy switchover (Make the standby management module active immediately) HP-Switch(Config show redundancy (Brief details on the redundant management and fabric modules) HP-Switch(Config show redundancy details (Displays the following).Flow Control will not allow packets to drop if the link is being saturated.By default multicast traffic is flooded through all ports except the port it was received on).HP-Switch(Config interface a4 (First step is to go into the interface) HP-Switch(eth-A4 flow-control (Second Step is to turn on Flow-Control on the interface) Management Modules (For 8000 series switches) HP-Switch(Config redundancy management-module nonstop-switching (Turns on nonstop-switching for redundant management modules.In Cisco terms it is referred to as Etherchannel."We have taken the active components off the backplane and put them onto cards, giving you the ability to swap them out, or upgrade them with higher-performance modules in the future.".




You May 100 words to make you sound smart audiobook Also Like, showing slide current_slide of total_slides - You May Also Like.Multicast and Multicast Routing, hP-Switch(vlan-10 ip igmp (Enables Internet Group Management Protocol controls.HP-Switch(Config router pim (Enables Pim Dense Mode Multicast Routing).HP-Switch(Config trunk a4-a7 trk1 trunk (Creates a 4 port bundled trunk port with interface a4-a7).HP-Switch(Config show vlan ports a1 (Shows the vlans belonging to a1).HP-Switch(config-ext-nacl 20 permit ip (Permit any to any for any IP service).Trust (Makes interface a1 a trusted dhcp snooping interface.e.Access Lists, hP-Switch(Config ip access-list extended 100 (Creates an extended access list 100).
Tell us what you think - opens in new window or tab.
HP-Switch(Config show spanning-tree (Shows spanning tree information for vlans and ports).